Anaerobic Threadlocker Adhesive(henkel loctite quality): Loctite 290 Equivalent High Strength Penetrating Threadlocking adhesive

Loctite 290 Equivalent Penetrating Threadlocking adhesive

from Tina(hengying@cnhybond.com 0086-18927302778 Skype:hengying11)

1. RODUCT DESCRIPTION

HYBOND 290 provides the following product characteristics:
Technology: Acrylic
Chemical Type: Dimethacrylate ester
Appearance (uncured): Green liquid
Components: One component - requires no mixing
Viscosity: low
Cure : Anaerobic
Secondary Cure: Activator
Application :Threadlocking
Strength: Medium to High

HYBOND 290 is designed for the locking and sealing of threaded fasteners. Because of its low viscosity and
capillary action, the product wicks between engaged threads and eliminates the need to disassemble prior to
application. The product cures when confined in the absence of air between close fitting metal surfaces and
prevents loosening and leakage from shock and vibration. The product can also fill porosity in welds, castings and
powdered metal parts

2. TYPICAL PROPERTIES OF UNCUREDMATERIAL

Specific Gravity @ 25 °C 1.08
Flash Point - See MSDS
Viscosity, Brookfield - RVT, 25 °C, mPa·s (cP):
Spindle 1, speed 50 rpm 20 to 55LMS

3. TYPICAL PERFORMANCE OF CURED MATERIAL

Adhesive Properties
After 24 hours @ 22 °C
Breakaway Torque, ISO 10964:
M10 steel nuts and bolts N·m 10
(lb.in.) (90)
Prevail Torque, ISO 10964:
M10 steel nuts and bolts N·m 29
(lb.in.) (260)
Breakloose Torque, ISO 10964, Pre-torqued to 5 N·m:
M10 steel nuts and bolts N·m 30
(lb.in.) (270)
Max. Prevail Torque, ISO 10964, Pre-torqued to 5 N·m:
M10 steel nuts and bolts N·m 40
(lb.in.) (350)
Compressive Shear Strength, ISO 10123:
Steel pins and collars N/mm² ≥5.4LMS
(psi) (≥780

4. For Assembly

For Blind Holes, apply several drops of the product down the internal threads to the bottom of the hole
For Porosity Sealing
(1). Clean area and apply localized heat to the area to
approximately 121°C.
(2). Allow to cool to approximately 85°C and apply the
product.

5.For Disassembly
.
(1). Remove with standard hand tools.
(2). In rare instances where hand tools do not work because of excessive engagement length, apply localized heat
to nut or bolt to approximately 250 °C. Disassemble while HOT

6. For Clean up

Cured product can be removed with a combination of soaking in a HENG YING solvent and mechanical abrasion
such as a wire brush.

7. Storage
Store product in the unopened container in a dry location. Storage information may be indicated on the product
container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product
properties. Material removed from containers may be contaminated during use. Do not return product to the
original container.HYBOND Corporation cannot assume responsibility for product which
has been contaminated or stored under conditions other than those previously indicated. If additional information

is required, please contact us.